Instruction manual

To enter Analog Output Setup in TACHLINK simply click on the corresponding tab.

4.2.5.1.1. Source

Source is a Fixed Range Constant. Analog Output can be assigned to any

input. The choices are Input A, Input B, Equation or Off. Input A & B

are the normalized values from section 4.2.2.6. Equation uses the

mathematical result from section 4.2.2.2 in addition to Normalization. The

output can also be turned off by selecting Off.

From the Analog Output SETUP pages described in section 4.2.5.1 depress

to enter the Analog Output Setup. Depress again

to make Source active. Depress

to toggle through

Input A, B, Equation and Off. In this example Input A is

selected. When complete, navigate to the next constant

using

or save changes as described in section 4.1.2..