Instruction manual

Depress to navigate to Preset. With Preset highlighted depress to make constant

ctive for change. The sign preceding the base a

number is highlighted. Use

or to change

sign. Depress

the

to navigate the cursor to the first

digit to be changed for this example. Use

to increment or decrement the number as required. Use

for each additional digit to

hange. Change the exponent sign in the same manner as described for the sign preceding

e base number.

epress Next,

, to navigate to the Input B Setup page. When changes are complete,

depress

. If no mo e changes are to be made on this pager the user may depress Prev,

, multiple times to exit and save changes as described in section 4.1.2.

onfigure Input B.

4.2 and TT30 Only), Relay Output

1&2 / Digital Output Setup (Tachometer and Counter Mode)

; Relay 1 and 2 are based on

and power switching but do not

nductors. Each mechanical relay has a set of

normally open and normally closed contacts. Digital 1 & 2 are semi-

conductor based outputs that reduce reaction time, but switch lower power

levels and have only a true normally open condition. Just as with the

mechanical relays, there is no polarity associated with these outputs. The

switched outputs react when a particular setpoint is reached. A setpoint is a

If Direction mode is active, only Input A will be active and there will not

be a choice to c

.4. Digital Output 1&2 (TP30

The tachometer has four switched outputs

mechanical relays that provide high isolation

react as quickly as semi-co