Instruction manual

4.2.2.1.2. Direction Bit
When set for direction mode, the instrument can recognize an externally
applied logic level present at the Direction input. An AI-TEK BH series
bi-directional sensor can provide the logic level signal. The instrument can
be user-configured to react to either high (Bit High) or low logic (Bit
Low) level as a reversal in direction.
Once in INPUT SETUP, Direction is highlighted.
Depress
once for each choice of the Fixed Range
Variable. Pictured here,
is depressed until Dir. Bit
High is displayed. Once the selection is made, the user
an navigate to the next constant to change or view.
Depres
c
will highlight, and make active, Equation
sing
and Un
page the user m
its. If no more changes are to be made on this
ay depress Prev,
, to exit and save
changes as described in section 4.1.2.
39