Specifications

Connect-Tek Over IP

Step 7. Follow the instructions on the screen. For example, simply type “I” for setting your IP, type “M” for

changing the machine name, and so on. Here is a reminder for you, please type “W” after you made

any change.

B. Initial Setting Procedures

Before installing your CTIP-01, please refer to the “Contents” section of Chapter 1 to ensure that you have

all of the necessary items for the following proper installation.

Just choose either one method of assigning an IP address. There are 3 available methods of assigning an

IP address to the CTIP-01:

1. DHCP

Step 1: Connect your network to the LAN Port of CTIP-01. The first time the unit is booted, it will perform

DHCP lease request to get an IP address. Therefore, you’d better connect it to the network before

turning it on.

Step 2: Please have your MAC address. You can find it on a white sticker on the bottom of the CTIP-01.

Here is an example, 00-0E-C5-00-08-1A.

Step 3: Power on the CTIP-01 and connected to the network via WAN port on the rear panel. The DHCP will

automatically assign an IP address to the CTIP-01.

Step 4: Access the DHCP log from your file server. A simple DHCP log looks similar to the following:

Step 5: From the above DHCP log, you can easily find the DHCP assigned an IP to the CTIP-01,

192.168.22.4. Once you have located this IP address, do NOT power off the CTIP-01 or your DHCP

server since it might lease a different IP address.

Step 6: Simply open a web browser and type https://192.168.22.4 to access your CTIP-01. Login by using

“admin” for both username and password. NOTE: Please remember to type “s” after http. And,

you will see a Lock on the lower right corner of your screen. That means all of your information is

under the protection of 128-bit SSL Encryption.