User manual

Connect Tech Xtreme/SBC PCI-104 Single Board Computer - User Manual
Revision 0.03
25
Hardware Installation
1. Ensure all external system power supplies are off.
2. Install the Qseven module into P1. Be sure to follow the manufacturer’s direction for proper
heatsink/heatspreader installation.
3. Verify all jumper settings from the relevant sections, paying special attention the power selection
jumpers
Jumper
Function
Selection
Position
J1
PS/2 power
+5V
2-3
J2
Fan Power
+12V
1-2
J3
Fan PWM polarity
Positive
Off
J4
LVDS panel power
+3.3V
2-3
J5
LVDS backlight
enable polarity
positive
Off
J6
LVDS Backlight
Power
+12V
1-2
J7
Suspend Selection
S3
1-2
J8
Power Supply On
From Qseven module
2-3
4. Install the necessary cables for the application. At a minimum, this would include:
a) Power cable, either ATX or +5V/+12V only
b) Display cable, either VGA or LVDS
c) Keyboard, either PS/2 or USB
d) Power button, if applicable
For the relevant cables, see the Cables & Interconnect section of this manual
5. Stack any necessary PCI-104 modules on top of the Xtreme/SBC PCI-104 via P2, with the
appropriate mounting hardware
6. Connect the appropriate I/O peripherals to the interface cables: keyboard, mouse, Ethernet,
monitor, etc.
7. Connect the power cable to power supply
8. Turn on the supply.