Hardware Manual CAN-IB130/PCIe CAN-IB230/PCIe PCIe/104 CAN Interface The expert for industrial and automotive communication
IXXAT Headquarter IXXAT Automation GmbH Leibnizstr. 15 D-88250 Weingarten US Sales Office IXXAT Inc. 120 Bedford Center Road USA-Bedford, NH 03110 Tel.: +49 (0)7 51 / 5 61 46-0 Fax: +49 (0)7 51 / 5 61 46-29 Internet: www.ixxat.de E-Mail: info@ixxat.de Phone: +1-603-471-0800 Fax: +1-603-471-0880 Internet: www.ixxat.com E-Mail: sales@ixxat.
Content 1 Introduction ....................................................................................5 1.1 Overview ................................................................................. 5 1.2 Features .................................................................................. 5 2 Installation ......................................................................................5 2.1 Software installation .............................................................. 5 2.
Introduction 1 Introduction 1.1 Overview The IXXAT CAN-IB130/PCIe104 or CAN-IB230/PCIe104 are high-quality electronic components developed and manufactured according to the latest technological standards. This manual describes both, the CAN-IB130/PCIe104 interface board (passive) and the CAN-IB230/PCIe104 interface board (active). In the following both interfaces will be called "CAN interface board". 1.
Connections (1) Turn the PC off and pull the power cord. (2) Open the PC according to the instructions of the PC manufacturer and determine a suitable slot. The CAN interface board is designed according to the PC standard and can easily be installed into the corresponding slot. Do not use force when inserting it. (3) Be sure the interface is securely held in the PC. (4) Close the PC; the hardware installation is now complete.
Connections 3.2 Field bus connection The field bus connections are available with a galvanic isolation as an option. If the CAN interface board you use dosn't has such a galvanic isolation, CAN ground and PC ground are on the same potential. 3.2.1 CAN high speed (ISO 11898-2), channel 1-4 All CAN channels available on the CAN interface board do have an interface according to ISO 11898-2. The pin assignment of the signals (CANH high speed, CANL high speed, GND) is shown in table 3-1 and 3-2. 3.2.
Programming the firmware 3.2.5 Pin assignment of the DSub-9 plug (channel 1-4) If the special box header/DSub-9 adapter is used, the pin assignment of the DSub-9 plug is shown in table 3-2. Pin No.
Appendix only use the included accessories all cables must shielded the shield of the interfaces must be connected with the device plug and with the plug on the other side 8 Appendix 8.1 Technical data PCIe/104 interface: PCI Express Base Specification Rev. 1.1 TM TM PCI/104-Express & PCIe/104 Specification, Rev. 2.01 CAN transceiver (High Speed): TI SN65HVD251 CAN transceiver (Low Speed): TJA1054 LIN transceiver: TJA1020T CAN propagation delay: with galvanic isolation typ. 6 ns, max.
Appendix 8.2 FCC compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation Class A digital device – Instructions Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
