Operating instructions

SEA M300USERSGUIDE
PROJECTMANAGEMENT  98
Exit the M300 and save the demo project. We will see how to add another board to this project next.
Start the M300 and go into the board setup again (See “Board Setup” on page 105).
As you can see the demo project has a system board in the board project tree.
We will add a SEA Bus (SBus), type board next. This board allows you to add analog acquisition
events to the project.
Pick Type ‘SBus’ from type first and then for Name use ‘sbus’ and change the Number to 1. This
adds an sbus board number 1 to the project. We pick number 1 and not 0, since we used 0 before for
the system board.