Operating instructions
SEA M300USERSGUIDE
DATAOPERATIONS
80
ACQUIRINGDATA
To acquire data with the M300 system is fairly easy.
1. Start M300 system (See “How to Start M300” on page 34).
2. Load the desired project (See “Open Project” on page 93).
3. Pick acquisition from the mode group. This is the first button from the tool bar (See “Tool Bar”
on page 59).
4. Create a data file by typing file create in the command list (See “Command Bar” on
page 61). This automatically creates a file. Also you can use the file menu (See “File Menu” on
page 54).
5. If the record button is not pressed, click on it to set the record on (See “Tool Bar” on page 59).
6. Finally you click on the play button from the M300 tool bar (See “Tool Bar” on page 59).
Once the M300 is running and acquiring data you should always make sure of the following.