Operating instructions
SEA M300USERSGUIDE
GETTINGSTARTED
34
23. To delete to the end of a line: CTRL + K.
24. Use view menu to switch to hex mode when looking at binary data.
25. To insert special characters (such as degree and micron symbols) use the ‘misc’ menu, ASCII
TABLE menu item.
HOWTOSTARTM300
Start the M300 DAS using one of the following methods.
1. In the Desktop Manager, select the SEA tab in the application groups panel. Click on the M300
icon.
2. From a QNX shell in, type m300. This is a script which initiates the M300 DAS. Alternatively,
you can start the M300 directly by typing M300 & at the command prompt.
MAINWINDOW
The M300 Main Window is the primary launch point of all M300 operations. Both Acquisition and
Playback as well as UDP can be performed now from a single window. The M300 data displays can
be directly managed from this window as well as formulas and almost all project settings. If you wish
to learn more about each control/feature (See “M300 Main Window” on page 53).
HOWTOEXITM300
Exit the M300 by using on of the following methods.
1. From the File menu, select Exit. (Shortcut: Alt + F, X) or click on the close symbol (“X”) in the
upper right corner of the main interface window.