Operating instructions

M300USERSGUIDE SEA

GETTINGSTARTED



$ /bin/Fsys -f 2000 -i 4000 -Hdisk500

/bin/Fsys.atapi

$ /bin/Fsys.atapi

/bin/mount

$ /bin/mount -p /dev/hd0 /dev/hd0t78 /

/bin/mount

$ /bin/mount /dev/hd0t77 /hd

/bin/sinit

$ /bin/sinit TERM=qnx

In the QNX 4 system there are users assigned to the system. Each user has a login name and

password. To login into the QNX system:

1. Enter you username at the login prompt.

2. Enter you password at the password prompt.

WARNING:IfyouaregoingtoruntheM300duringthissession,youshouldNOTloginasroot/superuser.

Rather,youshouldset‐upauseraccount(ifnotalreadydoneso)withreasonableaccessrightsandprivileges.

Note: Ifyouenteranincorrectornon‐existentusername/password,forsecu rityreasons,QNXwillreturnto

theloginpromptwithoutprovidingnotificationoftheerror.

LOGOUT

TologoutfromtheQNXsystem

1. Type exit or logout at the QNX 4 command prompt.

STARTINGPHOTON

TostarttheQNXPhotonGUI

1. Type

ph at the QNX 4 command prompt (first you must login).

Note: Thesyst em can beconfiguredtostartPhotonautomaticallyafterbootupas opposedto the

traditionalloginthroughtheQNX4shell.Ifyouwishtohavethis,justcontactSEAforhelpongettingitdone.

GETTINGFAMILIARWITHPHOTON

The QNX Photon GUI (Graphical User Interface) has a similar interface much like any GUI you

might be familiar with already, with the exception that it is designed for a real-time operating system.