Operating instructions

M300USERSGUIDE SEA
SETUP  147
PIRAQBOARD
Address
(See “Address” on page 103).
State
(See “State” on page 103).
PB/UDP
(See “PB/UDP” on page 104).
Memory
PCI memory setting for Piraq board.
IRQ
Controls the Interrupt Request Line used by the Piraq 2 board. Note that some IRQ channels are
reserved and should not be used. Change this value only if you are sure it will not conflict with
another device.
DSPFile
Name of the DSP file to load into the Piraq board.
Watchdog
See board manual.
FirstGate
See board manual.
PhaseCorrect
See board manual.
ClutterFilter
See board manual.