Operating instructions

SEA M300USERSGUIDE
SETUP  128
CAMAC1D256BOARD
Address
(See “Address” on page 103).
State
(See “State” on page 103).
PB/UDP
(See “PB/UDP” on page 104).
Slot
CAMAC slot where the board is installed.
Command
For FSSP type, this value sets the initial range [0, 1, 2 and 3].
For PCASP, this value sets the initial pump state (0=off, 1=on).
SizeChannels
The number of size channels to acquire.
SourceFrequency
Source frequency setting for strobe channels.
StrobeChannels
The number of strobe channels to acquire.
DivideFactor
Divide factor and source frequency are used to setup the timing for strobe channels.
Range
A/D range selection.