Operating instructions

M300USERSGUIDE SEA
SETUP  121
2DGREYBOARD
Address
(See “Address” on page 103).
State
(See “State” on page 103).
PB/UDP
(See “PB/UDP” on page 104).
DMA
(See “DMA” on page 104).
BitShift
Controls how fast the image data is transferred from the probe. The length and quality of the
interface cable are limiting factors on the maximum bit shift possible. The higher the bit shift the
more data we can transfer from the probe.
IRQ
Interrupt channels used by the board to indicate when the data transferred is done. An IRQ cannot
be used by multiple cards in the M300.
Command
Initial command to probe. See the probe manual for detailed information on the command values
possible.
Done
(See “Done” on page 104).
Default
(See “Default” on page 104).
Cancel
(See “Cancel” on page 104).