Operating instructions

SEA M300USERSGUIDE
SETUP  110
the acquisition events is set in the buffer setup.
Up
Moves the selected item up the list by one. This changes the order of the acquisition event in the
acq.300 file. This is not the order in which the acquisition events will get acquired. The order for the
acquisition events is set in the buffer setup.
Down
Moves the selected item down the list by one. This changes the order of the acquisition event in the
acq.300 file. This is not the order in which the acquisition events will get acquired. The order for the
acquisition events is set in the buffer setup.
Insert
To insert an acquisition event, first you must click on a board entry from the project tree. Then you
can enter all the required values for the acquisition event. Once you are happy with your selection,
then you can click on the insert button.
If you click on an acquisition event from the tree, this will fill in all the information (name to offset).
Then if you click on the board entry (for the same event or another of the same board type), you are
able to modify the acquisition parameters and do the insert.
Remove
First click on the acquisition event from the project tree. Then you can click on remove to delete the
event from the project.
WARNING:Usecautionwhendoingthisasthereisnoun‐delete.Ifyouchangeyourmind,exittheM300and
don’tsavetheproject.
Done
This will close the acquisition setup window. Any changes made will be accepted.
WARNING:Ifyoudon’twantthechangestotakeeffect,exitM300,don’tsavetheM300project.
If you are happy with the changes to the acquisition setup, you can exit and save the project or just
save the project (from M300 project menu).
ProjectTree
The project tree is on the left hand side at the bottom of the acquisition dialog.
The project tree starts with the project name followed by all the boards in the project.
The acquisition events are possible only off each of the board entries. Not all board entries will have
acquisition events.
When you select the project name from the tree all items are disabled. You can’t really do much.
If you select a board entry, then you are able to add acquisition events to the project. You can also