Operating instructions

SEA M300USERSGUIDE

SETUP



106

modify button.

To remove a board, you must first click on the board on the tree. Then you click the remove button.

Once you remove the board it is gone from the project. This operation can’t be undone. If you don’t

want to change the project, then exit the M300 and don’t save the project when asked.

After you remove/modify the board name, the board files is still present in the system. If needed, it

must be removed manually. Having extra board files that are unused is confusing.

Boards with the state on are shown with a green dot before the board name. These are available for

acquisition.

Boards with the state off are shown with a red dot before the board name. These will not be used for

acquisition. The board address is still present and available for the system.

Name

This is the name of the board that was given by the user. The name of the board is case sensitive and

must be unique.

To modify the board name, the user can select it and change it to a new name. All entries in the

buffer table (buf.300) and acquisition table (acq.300) that use the name are also updated. However it

is impossible to change board name entries in other tables, such as formula (fml.300), buttons

(btn.300) and commands (cmd.300). The user must change these references manually, if

appropriate.

WARNING:Don’tusespacesforboardnames.Theboardnamesusefilesandcommandsandthismakesit

hardtoworkwith.

BoardType

Board type to be added to the board list. The M300 provides the user with a list of all the valid board

types supported by the system. This makes it easy to add a board.

You must pick a board type before inserting a new board.

You can’t modify the board type once the board as been inserted into the project.

Insert

This will insert the newly selected board to the list. You must first click on the project name from the

board tree.

For a list of boards and their settings (See “Board Setup Dialogs” on page 116).

Remove

Removes the selected board from the list. You must first click on the board name.