User manual

Connect Tech Xtreme/104 Plus, PCI-104 and PCI/104 Express Family User Manual

Revision 0.08

Xtreme/104 Installation Overview

Before you begin, take a moment to ensure your package includes the components shipped with

your product. These components should include:

One Xtreme/104 adapter

One CD containing software and documentation

DB-9 male fan-out cable or DB9 male cables (optional)

If any of these components are missing, contact Connect Tech (see more Contact Details) or

your reseller.

There are three stages to installing your Xtreme/104:

1. Hardware Configuration

Interrupts and Memory selection will be set by the host computer’s BIOS. This section

outlines jumper settings and the ID selection process.

2. Hardware Installation

Installation involves the physical connection of the Xtreme/104-Plus or Xtreme/104

Express within your computer’s PC/104-Plus stack. (Please note that you should

configure any jumper settings, such as ID or electrical interface, if required, prior to

installing the board.)

3. Software/driver installation

Load the appropriate driver for your Operating System, as found on the accompanying

CD. Installation guides are also available on the CD to aid you in this process.

Hardware Installation

Installing Xtreme/104-Plus or Xtreme/104PCI Cards Into Your System

Turn off the power to your system and open it to expose the PC/104 stack (consult your system’s

documentation for more information on this procedure).

Choose an available position in the PCIe/104 or PC/104-Plus stack, and set the ID jumpers or

rotary switch accordingly (see ID Selection). Insert the Xtreme/104-Plus or Xtreme/104 Express

adapter and reassemble the stack.

Hardware Configuration

Interrupts and Memory Address Selection

Xtreme/104 boards are PCI cards, so the host computer’s BIOS will automatically set interrupts

and memory addresses when you reboot after installation.