User manual

Connect Tech FreeForm/PCI-104 User Manual
Revision 0.07 29
9) If the programming is succesful you will see:
INFO:iMPACT - Current time: 2013-03-25 4:51:55 PM
// *** BATCH CMD : Program -p 1 -v -dataWidth 1 -spionly -e -v -loadfpga
PROGRESS_START - Starting Operation.
Maximum TCK operating frequency for this device chain: 10000000.
Validating chain...
Boundary-scan chain validated successfully.
1: Device Temperature: Current Reading: -273.00 C
1: VCCINT Supply: Current Reading: 0.000 V
1: VCCAUX Supply: Current Reading: 0.000 V
'1': SPI access core not detected. SPI access core will be downloaded to the
device to enable operations.
INFO:iMPACT - Downloading core file
C:/cad/Xilinx/13.4/LabTools/LabTools/virtex5/data/xc5vlx30t_spi.cor.
'1': Downloading core...
Match_cycle = 0.
LCK_cycle = NoWait.
LCK cycle: NoWait
done.
INFO:iMPACT:2219 - Status register values:
INFO:iMPACT - 0011 1111 1001 1110 0000 1010 1000 0000
INFO:iMPACT:2492 - '1': Completed downloading core to device.
'1': IDCODE is '202016' (in hex).
'1': ID Check passed.
'1': IDCODE is '202016' (in hex).
'1': ID Check passed.
'1': Erasing Device.
'1': Using Sector Erase.
'1': Programming Flash.
'1': Reading device contents...
done.
'1': Verification completed.
'1':Programming in x1 mode.
'1': Programmed successfully.
INFO:iMPACT - '1': Flash was programmed successfully.
Match_cycle = 2.
LCK_cycle = NoWait.
LCK cycle: NoWait
INFO:iMPACT - '1': Checking done pin....done.
'1': Programmed successfully.
PROGRESS_END - End Operation.
Elapsed time = 167 sec.