User manual

Connect Tech FreeForm/PCI-104 User Manual
Revision 0.07 27
Programming the Flash
1) Connect the JTAG programming cable to P2 ensuring that all JTAG signals align correctly.
Note that P2 also has the TRST signal on pin 1, which is not part of Xilinx’s Parallel or USB programming cables.
2) Add the appropriate jumper to J1.
3) Open the recently saved iMPACT project file
Example: {REFDIR}\fpga\\ise_projects\ref_design_fcg001rd\ ref_design_fcg001rd.ipf
4) Right click on the flash, and click ‘Set Programming Properties’
5) In Programming Properties dialog
a. Check Verify
b. Check Design specific Erase
c. Select automatically load FPGA with Flash Contents
d. Click OK