User manual

Connect Tech FreeForm/PCI-104 User Manual
Revision 0.07 26
7) Once the FPGA has been programmed successfully, you will see ‘Program Succeeded’
INFO:iMPACT - Current time: 2013-03-25 4:49:45 PM
// *** BATCH CMD : Program -p 1 -v -dataWidth 1
PROGRESS_START - Starting Operation.
Maximum TCK operating frequency for this device chain: 10000000.
Validating chain...
Boundary-scan chain validated successfully.
1: Device Temperature: Current Reading: -273.00 C
1: VCCINT Supply: Current Reading: 0.000 V
1: VCCAUX Supply: Current Reading: 0.000 V
'1': Programming device...
Match_cycle = 2.
LCK_cycle = NoWait.
LCK cycle: NoWait
done.
INFO:iMPACT:2219 - Status register values:
INFO:iMPACT - 0011 1111 1001 1110 0000 1010 1110 0000
Match_cycle = 2.
LCK_cycle = NoWait.
LCK cycle: NoWait
INFO:iMPACT - '1': Checking done pin....done.
'1': Programmed successfully.
'1': Verifying device...INFO:iMPACT:2502 - Complete word count is
9363744/32=292617'.
INFO:iMPACT:2495 - Readback Size is 9363744.
done.
'1': Verification completed successfully.
Match_cycle = 2.
LCK_cycle = NoWait.
LCK cycle: NoWait
INFO:iMPACT:579 - '1': Completed downloading bit file to device.
INFO:iMPACT:188 - '1': Programming completed successfully.
Match_cycle = 2.
LCK_cycle = NoWait.
LCK cycle: NoWait
INFO:iMPACT - '1': Checking done pin....done.
'1': Programmed successfully.
PROGRESS_END - End Operation.
Elapsed time = 6 sec.
8) Save the iMPACT project (File -> Save Project As)
Example: {REFDIR}\fpga\\ise_projects\ref_design_fcg001rd\ ref_design_fcg001rd.ipf