User manual

Connect Tech FreeForm/PCI-104 User Manual
Revision 0.07 25
Programming the FPGA
1) Connect the JTAG programming cable to P2 ensuring that all JTAG signals align correctly.
Note that P2 also has the TRST signal on pin 1, which is not part of Xilinx’s Parallel or USB programming cables.
2) Remove all jumpers from J1; to ensure the flask is not loaded into the FPGA.
3) Open the recently saved iMPACT project file
Example: {REFDIR}\fpga\\ise_projects\ref_design_fcg001rd\ ref_design_fcg001rd.ipf
4) Right click on the FPGA and click ‘Set Programming Properties’
5) Select Device 1, check verify, and click OK
6) Right click on the FPGA and click ‘Program’