User manual
Chapter 3: Software Installation - Windows 95 3-35
Echo User's Manual, ver. 0.00
5. A window will now appear with the headings RESOURCE
TYPE and SETTING. The settings shown are probably wrong.
Do not worry we will change them later. Click NEXT.
Another window will appear. Click on
FINISH.
6. You will now see a
SYSTEMS SETTINGS CHANGE window
prompting you to reboot the machine and since the settings
are wrong click
NO. If you have more Echo serial ports to
add you should repeat steps 4 - 6 until you have enough
additional new COM ports installed.
7. You now go to the
SYSTEM PROPERTIES menu by clicking
on the SYSTEM icon in the CONTROL PANEL. Click on the
DEVICE MANAGER tab. A list of devices will appear. Click on
PORTS (COM & LPT)
and it will expand showing all the ports.
Choose the new COM port just created. Click on
PROPERTIES (double clicking the COM port will also bring up
PROPERTIES
). This is where we tell Windows 95 about the
settings for the Echo adapter.
8. You should now have a
COMMUNICATIONS PORT (COM??)
PROPERTIES
window. Click on the RESOURCES tab and you
should see the current settings for this port. These are the
settings we want to change. There are three steps to follow:
8.1. First select
BASIC CONFIGURATION 8 in the SETTINGS
BASED ON
area.
8.2. We now need to change the
INPUT/OUTPUT RANGE under
the RESOURCE TYPE heading, so double click there. A
new window will appear and this is where you can enter
the Echo I/O port address (Example 200-207) or use the
UP/DOWN arrows of the dialog box to find one to
select. Click
OK.
8.3. We now need to change the
INTERRUPT REQUEST under
the
RESOURCE TYPE heading, so double click there. A
new window will appear and you can now enter the IRQ
of you Echo card (example IRQ 10) or use the
UP/DOWN arrows of the dialog box to find one to
select. Click
OK. You should now be back at the
COMMUNICATIONS PORT (COM??) PROPERTIES window, so
click OK.