User manual

3-8 Chapter 3: Software Installation - Multiuser DOS
Echo User's Manual, ver. 0.00
Multiuser DOS 7 GOLD
This section describes how to install an Echo adapter into a
Multiuser DOS 7 GOLD system. For further information please
refer to Boards and Ports under the Installation and
Configuration section of the Multiuser DOS 7 GOLD Users
Guide.
Technical Tip
1. You can run under DOS the DOS programs porttest.exe and
portfind.exe to verify your settings and assure you have no
hardware conflicts. You will find these programs on the
DFlex DOS Driver diskette (p/n: DISK306).
2. Please go to the Download Zone or the Knowledge Database in
the Support Center on the Connect Tech website for product
manuals, installation guides, device driver software and
technical tips. If these sources do not provide you with the
help you need please contact a Connect Tech Technical
Support Representative via email, telephone or fax for
further information (numbers and addresses are found
inside the front cover of the manual).
Configuration
Multiuser DOS 7 GOLD configures standard serial devices via
the
CONFIG.EXE utility. To install an Echo adapter please follow
these procedures:
1. Type
CONFIG at the C:\ prompt.
2. Select
Boards and Ports.
3. Hit the
INSERT key to add another board.
4. Select
Standard Board.
5. Edit board details as follows:
Board Name you can change it to read Echo
Board Model Standard Driver
Number of Ports 8
IRQ Number the IRQ selected for the Echo
adapter
I/O Port or Poll Reg. 0000
6. Hit the
ALT key and then select Assign/Edit Ports. Here you can
choose one of the predefined stations, modems or printers and
assign it to this port.