Technical data

Commissioning

3.4 Configuring the drive components

Connection of the SINAMICS S120 to the Technology CPU

Product Information, 09/2011, A5E00480378-04

14. Select the connected motor. If a motor with a DRIVE-CLiQ interface is used, select this

setting. The motor data is then read from the electronic nameplate of the motor via the

DRIVE-CLiQ connection. Alternatively, you can select the (standard) motor from a list,

or enter the motor data directly. Then click "Next" to confirm the setting.

Note

If you select a "Motor with DRIVE-CLiQ interface", the motor data will not be read

immediately from the electronic nameplate of the motor. The data will not be transferred

until you switch to online mode.