Technical data

Technology DBs
CPU 317T: Technology Functions
7-42 A5E00251798-03
ErrorID Error message Possible causes To correct or avoid errors Interrupts in
S7T Config*
Synchroni-
zation object
Interrupts in
S7T Config*
Synchroni-
zation axis
8049 Illegal object
combination
Faulty combination of
technology objects.
Examples:
• Axis_2 was set as
leading
synchronization axis
for Axis_1, while
Axis_1 is set as
leading axis for
Axis_2.
• All synchronized axes
are processed at
different run levels.
• Set a definite leading /
following axis
combination.
• Assign the leading /
following axes to the
same run level (usually
the interpolator cycle).
20007 20007
804A The required object
interconnection is
missing
No allowances have been
made in the application
program for relevant
combinations of leading /
following axes and cam
disks.
Set the required leading axes
and cam disks in the
"Configuration" section of the
synchronization object of the
following axis.
30008 30008
804B Limit switch
actuated; illegal
command
A hardware
limit switch is actuated.
Permitted are only motion
commands in direction of
the operating range.
Check the mechanical
installation and the wiring.
Correct any programming
errors or use the software
limit switches.
50009
8063 Cam is not
interpolated
At the start of camming, it
was detected that the cam
was not interpolated yet.
Check the current cam status
at the technology DB. Add the
missing points or segments,
then interpolate the cam.
50002
8064 Failed to access the
cam
• Can not find the
specified cam disk.
• The cam disk is not
interconnected with
synchronous
operation.
• The cam disk is busy.
Check the cam disk and all
possible interconnections with
the axes (configuration of
synchronism).
50001,
50004
8065 Range violation
at the cam
A specified cam
interpolation point violates
the defined cam range.
Check the start and end
positions of cam
synchronization and
desynchronization.
50003
8072 Can not enable /
disable
synchronism
This error is caused by an
illegal status of the
leading axis during
synchronization and
desynchronization.
Example: The lead
ing axis
reverses during position-
related synchronization.
Check the motion of the
leading axis, or select a
different synchronization
strategy.
50007
8073 Violation of dynamic
values at the master
during synchronous
operation
The dynamic values at the
leading axis are too high
during synchronization
and desynchronization
(e.g. acceleration values
too high)
Check the motion of the
leading axis, or select a
different synchronization
strategy.
50009