Technical data

Technology functions
CPU 317T: Technology Functions
6-190 A5E00251798-03
MC_CamInterpolate - ErrorIDs
ErrorID Warning Description / to correct or avoid error
0000 No warning -
0027 Interpolation property can not be
maintained
A cam disk interpolation property could not be maintained
at the interpolated cam disk.
Example: A cam disk contains only a polynomial value with
a different gradient at its start and end point.
ErrorID Error message Description / to correct or avoid error
0000 No error -
8001 Internal fault Faulty or inconsistent project / software.
8005 Command canceled because of
input buffer overflow
The rate at which the user program outputs commands to
the technology is too high.
8007 An internal error has occurred at the
job interface
Due to an internal problem in the S7 system, commands
can not be accepted.
Check the consistency of your project data, then download
all system data to the module again.
8043 Illegal parameter value
Mode = 167, for example.
8044 Task not supported by the
technology object
Send a command to a cam, for example.
8045 Illegal command with current status • The cam is interpolated already.
• An MC_CamSectorAdd is busy adding interpolation
points to a cam disk.
(the cause can only apply to firmware version V3.0.x of
the integrated technology.)
804C Command output rate too high The command output rate with the same instance DB was
higher than the command interface was able to accept.
The second command is rejected in order not to violate
consistency the first.
For high command output rates, always use a separate
instance DB, or send the command again. Please note,
that although the first accepted command may be busy,
you may not be able to monitor it at the status outputs.
8050 Technology not ready During testing with breakpoints (CPU in HOLD), the
technology function has output a new command to the
technology. The command is rejected.
8051 Read / write access denied. Read / write access to the relevant technology object was
not possible.
This error may occur when a cam disk is tracked actively
in a synchronous operation and MC_CamInterpolate is
started.