Technical data

Technology functions
CPU 317T: Technology Functions
6-180 A5E00251798-03
6.4.2 FB 435 MC_CamSectorAdd - Adding cam segments
Purpose
• The technology function "MC_CamSectorAdd" adds new interpolation points or
polynomials to a cam disk.
Applicable to
• Cam disks
Requirements
• The cam is in editing mode
Editing mode is started by the technology function "MC_CamClear" and ends
with the interpolation of the cam by the technology function
"MC_CamInterpolate". This enables operation of the cam disk for camming.
Overriding commands
An MC_CamSectorAdd command can not be canceled by any other command.
An MC_CamSectorAdd command does not cancel any other commands.
Input parameters
Parameter Data type Start value Description
CamTable INT 0 Number of the cam disk technology DB
Execute BOOL FALSE Start at the positive edge
Data ANY -- Data area of the cam segments to be added
(interpolation points interpolation points or
polynomials).
The data area has a maximum length of 240 bytes
(equivalent to 30 interpolation points, or 4
polynomials.)
table INT 0 Specification of the data area:
Value = 0: Polynomials (arithmetical function)
Value = 1: Position table