Technical data

Technology functions
CPU 317T: Technology Functions
A5E00251798-03
6-147
MC_CamInSuperImposed - Example "Base synchronism with superimposing
camming"
The signal profile of the example below demonstrates the effect of absolute base
synchronism and superimposing camming.
Phase one - Base synchronism
Exe_1 starts absolute base synchronism. Synchronization starts according to
Mode = 0 at "MC_GearIn" with the default settings in S7T Config (synchronization
starting at leading axis position 100 with dynamic setpoints.) Synchronization starts
when the leading axis has reached (Axis_1) position 100. After a short delay,
InGear_1 reports that absolute base synchronism is reached.
Phase two - Base synchronism and superimposing camming
Exe_2 starts superimposing camming. The default start position of superimposing
slave is 0. After a short delay, InSync_2 indicates that superimposing cam
synchronism is reached. The slave position is derived from the sum of the
"Base slave position" (identical with master position (Axis_1)) + "superimposing
slave position".