Technical data

Configuration
CPU 317T: Technology Functions
4-94 A5E00251798-03
Correction options
Adjustment options (a = preset; b = result):
• If the absolute value of the spacing between segments or interpolation points is
less than the minimum value, a correction is not made. The discontinuity point
is retained. When this discontinuity point is accessed, the right-hand boundary
point is output.
• If the absolute value of the spacing between segments is greater than the
minimum value and less than the maximum value, correction is made by
joining the segment end points. The mean value of the spacing of the function
is used for the correction. The shape of the segments is affected as a result.
• If the absolute value of the spacing between segments exceeds a maximum
value, a correction is made by performing an interpolation between the two
segments. This results in insertion of a new segment.
Assessment of the domain and of the range of values
The point of discontinuity is corrected according to the evaluation for the domain
and range of values.
Marginal conditions at the point of discontinuity:
Condition Result
Deviation < minimum Retain discontinuity
Minimum < deviation < maximum Join segment end points
Deviation > maximum Interpolation (new segment)
Overlapping segments
When segments overlap, you can choose a criterion for the interpolation:
• the start point of the leading axis
• the end points of the leading axis
• chronological sequence