Technical data

Configuration
CPU 317T: Technology Functions
A5E00251798-03
4-85
4.6.5 Desynchronization
You can set the desynchronization conditions in the "Gear synchronization" and
"Cam synchronization" tab of the Synchronous operation > Default dialog box.
The desynchronization condition is set in the "Desynchronization" drop-down list.
Setting Meaning
Effective immediately Desynchronization starts immediately after the start of the function.
The settings in "DeSync master setpoint", "DeSync following axis" and
"Position reference" are ignored.
Preset desynchronization
position of the leading axis
(gearing)
At position of leading axis
(synchronization cam)
Desynchronization starts, based on the leading axis position set in
"DeSync master setpoint."
The setting in "DeSync following axis" is ignored.
Preset of the following axis
position for desynchronization
(gear synchronization)
At the leading axis position
(synchronization cam)
Desynchronization starts based on the following axis position set in
"DeSync following axis."
The settings in "DeSync leading axis" are ignored.
End of cam disk cycle
(only with camming)
Desynchronization starts at the end of the current cam disk cycle.
Most recent setting Not applicable