Technical data

Configuration
CPU 317T: Technology Functions
A5E00251798-03
4-81
4.6.4 Synchronization
You can set the synchronization conditions in the "Gear synchronization" and
"Cam synchronization" tab of the Synchronous operation > Default dialog box.
The synchronization condition is selected from the "Synchronization" drop-down
list:
Setting Meaning
Effective immediately Synchronization starts immediately after the start of the function.
The settings in "Sync. pos. master setpo
int", "Sync. pos. following axis"
and "Position reference" are not evaluated.
Preset synchronization position
of the leading axis
The synchronization criterion is applied irrespective of the leading axis
position. The synchronization position is defined in "Sync. pos. master
setpoint."
The setting in "Sync. pos. following axis" is ignored.
Preset synchronization position
of the following axis
(only for gearing)
The synchronization criterion is applied irrespective of the following
axis position. The synchronization position is defined in "Sync. pos.
following axis."
The setting in "Sync. pos. master setpoint" is ignored.
Transition at the end of the active
cam disk
(only with camming)
This can only be set with relative leading axis reference.
Synchronization criterion is the control value position at the end of the
current cam disk cycle.
The setting in "Sync. pos. following axis" is ignored.