Technical data

Learning units
3.6 6. Step: Configuring the drive in HW Config
Sequence Activity Result
7 Set the "Synchronize drive with equidistant DP cycle", then set the time coefficients as shown below.
8 Click "Alignment". The following components are aligned to the
set values:
• DP cycle in the DP master system
• All drive components of the same family
(here SINAMICS
®
) are aligned to the set
values.
9 Confirm with "OK".
10 Confirm the possible warning with "OK".
11 Finalize your HW configuration by calling the Station > Save
and compile
command.
The system compiles your project, and adds
the "Technology Objects" object to the
project window in SIMATIC Manager.
CPU 317T-2 DP: Controlling a SINAMICS S120
Getting Started, 12/2005, A5E00480391-01
3-9