User manual
Table Of Contents
- Limited Lifetime Warranty
- Copyright Notice
- Trademark Acknowledgment
- Contact Information
- BlueStorm/Express Installation Overview
- Hardware Configuration
- Interrupts and Memory Address Selection
- RS-232 Electrical Interface
- RS-422/485 Electrical Interface
- Jumper Block Settings
- Tri-state Operation
- Installing the BlueStorm/Express into your system
- Software First Installation
- Hardware First Installation
- Windows XP Installation
- Port Settings
- Advanced Port Settings
- Software Settings for RS-422/485
- Specifications
Connect Tech BlueStorm/Express User Manual
Revision 0.02
16
Software Installation
Software First Installation
Find the driver install package on your CD and run DpInst.exe in the directory. The installer will
guide you through the process. The board will then be detected and installed when the board is
physically added to the system. Software First installs are a great way to update existing drivers.
Connect Tech provides QNX 4.X/6.X, Linux, Windows 2000/CE/XP/XP x64/XPe/Server
2003/Server 2003 x64, and Vista support for BlueStorm/Express.