User manual

Connect Tech Blue Heat/Net User Manual
52 Revision 0.17
Saving To Flash
When you make configuration changes, the changes are stored temporarily in memory. If you
reboot your Blue Heat/Net at this point, any configuration changes you made will be lost.
To permanently save your changes, you need to save them to Flash. In order to do this, click the
Save to Flash button on the upper right-hand side of the Web Configuration Manager page.
If there are changes that need to be saved, the Save To Flash button will be yellow. Click the
Submit button to permanently save any configuration changes to the Flash Memory so they will
be present when you reboot your Blue Heat/Net.
Figure 19: Saving To Flash
If you haven't made any configuration changes, the Save To Flash button will remain grey.