User manual

Connect Tech Blue Heat/Net User Manual
Revision 0.17 33
1 to the FIFO size of the UART (default is FIFO size)
The following options are not implemented
[local_loopback= | llb=]
[special_char_mode= | scm=]
[error_char= | errch=]
[break_char= | brkch=]
[event_char= | evtch=]
[use_xoff_xon_limits= | xlim=]
[xofflim=]
[xonlim=]
[escape_char= | esc=]
pson
Syntax: pson [port#][p=][flags=][+d]
Description: This command sets the Personality or profile of a port. It establishes the
application that will use the port.
Options: port#
This specifies the port number. This number can be any valid port number
starting at 1 to the number of ports available on the particular Blue Heat/Net
unit. If the port number is omitted, the command returns the personality of all
ports on the Blue Heat/Net.
p=
This sets the personality string to the value supplied (up to 32 characters).
Default is ctid_portd.
flags=
This sets the personality flags to the value supplied (entered as a HEX value).
0 to 0xFFFF. Default is 0x0001 (RE_SPAWN)
+d
This sets the personality flags to the default values.
NOTE: The [p=] and [flags=] options are only available
when the user logs into SCM using the “backdoor”
password. Contact [e-mail] for this
password.
save
Syntax: save
Description: This command saves the setting changes into the CDS in the non-volatile (Flash)
memory.
Options: (none)
update
Syntax: update <-os | -loader | -jffs> [server_ip= | sip=] [file=]
Description: Download and store (in Flash memory) a new uClinux Operating System image
or a new Loader/SCM image. The download is conducted by a TFTP download
from a Server. After download the image file is checked as being a valid gzip
file (file is decompressed to validate its contents), and then the file is stored in