User manual

Connect Tech Blue Heat/Net User Manual
Revision 0.17 27
 boot Bootup settings
 cfg SCM operational settings
 exit Exits the SCM application (and optionally reboots the Blue Heat/Net)
 help Brief list of available commands and their syntax
 info Blue Heat/Net general information and Flash verification
 net Network settings
 port Serial port settings, line interface settings and UART information
 pson Personality settings
 save Save setting changes to Non-volatile (Flash) storage
 update Download (via TFTP) and Flash a new Operating System
(uClinux) and Loader/SCM image.
Command Details
boot
Syntax: boot [mode=] [file=] [delay=]
Description: This command establishes the Blue Heat/Net boot-up mode. For a detailed
description of the boot-up process of the Blue Heat/Net, see How the Blue
Heat/Net Boots up in the Appendix.
Options: mode=
A comma-separated list of the following sub-options. Each sub-option is
preceded by either a + or a – to indicate if the sub-option is enabled or disabled.
±flash Enables or disables the ability to boot from the Flash memory.
±bootp Enables or disables the ability to obtain the boot-up information from a
Server.
±tftp Enables or disables the ability to download and boot from a file located on
a Server.
file=
This option specifies the default file name used for the boot-up (if TFTP boot is
enabled) and also the default file name when using the flos command.
This can be any sequence of characters up to 128 characters in length. (The
default is BHNuClinux_vvv.gz, where vvv is the current version number of the
“Operating System image”).
delay=
This sets the time duration for accessing the SCM application. It can be set from
2 to 30 seconds, the default is 30. (See the section How the Blue Heat/Net
Boots up for more information).