Specifications

(
2
)
Rear
p
anel of the camera control unit
① [CAMERA] connector
This connector is used to connect the camera head and the camera control unit with the
camera cable.
When insert the connector, please confirm the position of the guide and screw up
tightly.
If it is loose, it may cause some noise.
② [SYNC OUT] connector
(1) Pulse outputs
Use them when other equipment required pulses (HD, VD, and SYNC) to
be synchronized with the camera. When the external sync-operation, the
pulse
of HD, VD and SYNC are regenerated inside of the camera control unit and
are output to each pins as followings. When no pulses from outside (at the
internal sync-operation) , HD,VD and SYNC generated inside are come out.
(2) Trigger input
When required random trigger shutter operation between other equipment
input RTS pulse from pin number 1. And short pin number 2 to pin number 4
or set the shutter switch on the front panel to ” RDM “.
Then index pulse to be synchronized with video signal is output to pin
number 3 . (Refer to Timing Chart)
① TRIG INPUT
② MODE SELECT
③ INDEX OUTPUT
④ GND
⑤ VIDEO OUTPUT
⑥ GND(VIDEO)
⑦ SYNC OUTPUT
⑧ GND(SYNC)
⑨ HD OUTPUT
⑩ GND(HD)
⑪ VD OUTPUT
⑫ GND(VD)
6
The ali
g
nment of the rece
p
tacle di
p
p
osts
12 terminals
(
female
)
(
rear view
)