Specifications
Table Of Contents
- Imprint
- Documentation Representative
- © HYDAC FILTER SYSTEMS GMBH
- Contents
- Preface
- Safety information
- Storing the CS
- Decoding the model code label
- Checking the scope of delivery
- CS1000 Features
- CS1000 Restrictions on use
- CS1x1x dimensions (without display)
- CS1x2x dimensions (with display)
- Hydraulic connection types
- Fastening / mounting the CS1000
- Display rotatable/Adjustable As Needed
- CS1000 hydraulic installation
- Electrical connection of the CS1000
- Setting the measuring mode
- Operating the CS1x2x using the keypad
- Overview of menu structure
- Using switching output
- Setting limit values
- Reading the analog output
- Status Messages
- Connecting CSI-D-5 (Condition Sensor Interface)
- Connecting the CS1000 to an RS-485 bus
- Communicating with the CS1000 via the RS-485 bus
- Taking the CS1000 out of operation
- Disposing of CS1000
- Spare Parts and Accessories
- Cleanliness classes - brief overview
- Checking/resetting default settings
- Technical data
- Recalibration
- Customer Service
- Model Code
- EC declaration of conformity
ContaminationSensor CS 1000 Connecting the CS1000 to an RS-485 bus
HYDAC FILTER SYSTEMS GMBH
en(us)
Page 93/112
BeWa CS1000 3764916 300 en-us 2012-08-29.doc 2012-08-29
Connecting the CS1000 to an RS-485 bus
The RS-485 interface on the CS1000 is a two-wire interface and operates in half-
duplex mode.
The number of CS1000s per RS-485 bus is limited to 26. Use letters A to Z to
address the HECOM bus address.
The length of the bus line and the size of the terminating resistor depend on the
quality of cable used.
Connect several CS1000's using the RS-485 interfaces according to the following
illustration:
Item Code Part no.:
1 Converter RS232 <-> RS485 6013281
1 Converter USB <-> RS485 6042337
2.1 Connection cable RS232, 9-pole -
2.2 Connection cable USB [A] <-> USB [B] -
3 Recommended cable twisted pair -
4 Terminator ~ 120 Ω -