Specifications
Table Of Contents
- Imprint
- Documentation Representative
- © HYDAC FILTER SYSTEMS GMBH
- Contents
- Preface
- Safety information
- Storing the CS
- Decoding the model code label
- Checking the scope of delivery
- CS1000 Features
- CS1000 Restrictions on use
- CS1x1x dimensions (without display)
- CS1x2x dimensions (with display)
- Hydraulic connection types
- Fastening / mounting the CS1000
- Display rotatable/Adjustable As Needed
- CS1000 hydraulic installation
- Electrical connection of the CS1000
- Setting the measuring mode
- Operating the CS1x2x using the keypad
- Overview of menu structure
- Using switching output
- Setting limit values
- Reading the analog output
- Status Messages
- Connecting CSI-D-5 (Condition Sensor Interface)
- Connecting the CS1000 to an RS-485 bus
- Communicating with the CS1000 via the RS-485 bus
- Taking the CS1000 out of operation
- Disposing of CS1000
- Spare Parts and Accessories
- Cleanliness classes - brief overview
- Checking/resetting default settings
- Technical data
- Recalibration
- Customer Service
- Model Code
- EC declaration of conformity
ContaminationSensor CS 1000 Reading the analog output
HYDAC FILTER SYSTEMS GMBH
en(us)
Page 55/112
BeWa CS1000 3764916 300 en-us 2012-08-29.doc 2012-08-29
Reading the analog output
Depending on CS model, the analog output is available as a 4 ... 20 mA or 2 ... 10 V
signal.
You can recognize the type of analog output from the model code of the sensor.
CS Model code Analogue output
CS 1 x x x - A – x – x – x – x /-xxx 4 … 20 mA
CS 1 x x x - B – x – x – x – x /-xxx 2 … 10 V
Observe the design of the analog output in the order. It is not possible to internally
change the analog output over later.
In the measuring menu, select one of the following signals for the analog output:
SAE classes acc. to AS 4059
ISO Code acc. to 4406:1999
ISO Code acc. to 4406:1987
NAS class 1638
Hydraulic fluid temperature