Specifications
Table Of Contents
- Imprint
- Documentation Representative
- © HYDAC FILTER SYSTEMS GMBH
- Contents
- Preface
- Safety information
- Storing the CS
- Decoding the model code label
- Checking the scope of delivery
- CS1000 Features
- CS1000 Restrictions on use
- CS1x1x dimensions (without display)
- CS1x2x dimensions (with display)
- Hydraulic connection types
- Fastening / mounting the CS1000
- Display rotatable/Adjustable As Needed
- CS1000 hydraulic installation
- Electrical connection of the CS1000
- Setting the measuring mode
- Operating the CS1x2x using the keypad
- Overview of menu structure
- Using switching output
- Setting limit values
- Reading the analog output
- Status Messages
- Connecting CSI-D-5 (Condition Sensor Interface)
- Connecting the CS1000 to an RS-485 bus
- Communicating with the CS1000 via the RS-485 bus
- Taking the CS1000 out of operation
- Disposing of CS1000
- Spare Parts and Accessories
- Cleanliness classes - brief overview
- Checking/resetting default settings
- Technical data
- Recalibration
- Customer Service
- Model Code
- EC declaration of conformity
ContaminationSensor CS 1000 Operating the CS1x2x using the keypad
HYDAC FILTER SYSTEMS GMBH
en(us)
Page 36/112
BeWa CS1000 3764916 300 en-us 2012-08-29.doc 2012-08-29
Deactivate display FREEZE
If display FREEZE is set to MANUAL in the PowerUp menu:
Press the following two keys simultaneously to return to the current display:
The display switches to the preset display.
All values present in the FREEZE memory are deleted.
If the display FREEZE is set to TIMEOUT in the PowerUp menu:
You are returned automatically to the current display after 10 times the value for
MTIME, or manually by pressing both arrow keys simultaneously.
The factory setting of MTIME is 60 seconds x 10 = 600 seconds = 10 minutes.
Menus and modes
The sensor has the following two operating levels / menus.
Menus Mode Description Page
PowerUp Menu PowerUp Mode
You carry out the basic
settings in this menu.
36
Measuring Menu Measurement mode
This menu starts automatically
after powering up.
40 / 44
PowerUp Menu
You can carry out the basic settings for operation of the CS in the PowerUp menu.
Selection To do
Start the PowerUp menu
Press any key while the supply voltage to the
sensor is switched on / generated.
Exit the PowerUp menu without
saving
Scroll through to CANCEL and press the
o.k.
-key.
If a key is not pressed within 30 seconds, the
system jumps back automatically.
Exit the PowerUp menu after
saving.
Scroll through to SAVE and press the
o.k.
-
key.
PowerUp Menu:
Code
MODE
Select measurement mode
mTIME
Set measuring duration
pPRTCT
Set pump protection time
ADRESS
Set bus address