Installation Instructions

27
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
2
2000 Versatile
Connector
1
Assembled
Bench
3
Left Armrest
9/16” (16 mm) Socket wrench
Not available in metric
Hardware Included
Bench Hardware
(4) 2000 Versatile Connectors
(4) 3/8” x 3/4” Hex bolts
(4) Diamond washers
(4) 3/8” x 2-1/4” Hex bolts
(4) Long bushings
Instructions for:
Bench & Armrests (BH2000)
Bench (BH2020)
Bench Armrests (BA2020)
Bench Hardware Kit (BHK2000)
Note: Check all bolts every three months or as needed
to insure all connector hardware is securely fastened.
Step 1
Position Bench over sockets on a fully
installed 2000 series dock.
Step 3
Position the 3 holes of the left Bench
Armrest with the 3 holes in the left
side of the Bench. Secure with bolts,
washers and short bushings. Install
the right Bench Armrest using the
same instructions.
Step 2
Insert the 2000 Versatile Connectors
into the corresponding dock sockets.
Secure 2000 Versatile Connectors
into socket from top with bolts and
washers as shown. Tighten to 25 lbs/ft
(3.46 kg/m) of torque. If attaching to
dock where Connectors are already
located, remove the bolts in the top
of the Connector and replace with
2-1/4” bolt and long bushing.
Note: A minimum of THREE (3) 2000
Versatile Connectors are required to
securely attach bench to existing
2000 series dock system.
Armrest Hardware
(6) 3/8” x 1-1/4” Xylon coated bolt
(6) 3/8” Split lock washer
(6) 3/8” Flat washers
(6) Short bushings
Tools Needed
2000 Series (HP) Bench & Armrests