Installation Instructions

2
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
1000 Series Low Profile (LP) Dock
Tools Needed Instructions for:
Float Section (FS1030), (FS160)
Float Connector (FC1010), (FC1010M)
9/16“ (16 mm) Socket wrench
Long rope for holding docks to
shore.
Before you begin: Determine the
layout and location of your dock.
1
Note: Check all bolts every three months or as needed to insure all connector
hardware is securely fastened.
Step 1
Install Float Connectors into all
Float Section sockets where other
Float Sections will be attached.
Secure Float Connectors into sockets
with bolts, washers, and bushings
provided (hand tighten only).
Connect 2 or 3 Float Sections prior
to placing into the water. Place
Float Sections into water, secure
to shore temporarily with rope.
Step 2
Position yourself carefully on the
floating Float Section(s). Continue
adding Float Sections by placing
them over the Float Connectors,
shift your body weight to the new
Float Section. Secure with bolts,
washers, and bushings.
Step 3
Tighten all bolts in the dock using 25
lbs/ft (3.46 kg/m) of torque. Anchor as
desired. NOTE: DO NOT SUBMERGE... a
minimum of 2” (5.08 cm) must show
above the water surface for venting
purposes.
Hardware Included
3/8” x 1-1/4” (10 mm x 35 mm)
Hex bolts
Diamond washers
Bushings
Float Connector
2
Align Float Section with Float Connectors
and position body weight here.
Shore