Installation Instructions

3
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
1000 Series (LP) Corner Float Section
Tools Needed Instructions for:
Corner Float Section (CFS1010)
9/16“ (16 mm) Socket wrench
Align Corner Float Section
with Float Connectors and position
body weight here.
2
1
Step 1
Install four Float Connectors into
Float Section sockets where the
Corner Float Section will be attached.
Secure Float Connectors into sockets
with bolts, washers, and bushings as
shown (Hand tighten only).
Step 2
Place the Corner Float Section over
the Float Connectors, then shift your
body weight carefully from the dock to
the Corner Float Section to hold it
in place. Secure with bolts, washers,
and bushings as in Step 1.
Step 3
Tighten all bolts in the dock using
25 lbs/ft (3.46 kg/m) of torque.
Anchor as desired.
NOTE: DO NOT SUBMERGE...
a minimum of 2“ (5.08 cm) must
show above the water surface
for venting purposes.
The Corner Float Section adds strength,
stability and more walking space to the
fingers of your dock.
Note: Check all bolts every three months or as needed to insure all connector
hardware is securely fastened.
Float Connector
Hardware Included
3/8“ x 1-1/4“ (10 mm x 35 mm)
Hex bolts
Diamond washers
Bushings