Installation Instructions

25
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
5
4
Tools Needed
Instructions for:
Self Wicking Planter (SWP1020)
1000 Pole Connector (PC1010), (PC1010M)
2000 Pole Connector (PC2022), (PC2022M)
9/16” (16 mm) Socket wrench
Hardware Included
Wicking Post
Rope wick
Black retaining washer
Hinge pin
Step 1
Insert Wicking Post thru Planter from
the top, making sure that it is fully
seated in the bottom of the pot.
Step 2
The rope wick has a long end and a
short end, relative to the knot. Insert
the short end of rope down thru the
Planter/Wicking Post assembly thru
the hole provided in the Wicking
Post. The rope wick should slightly
protrude from the bottom of the
Wicking Post with the knot resting at
the bottom of the Planter.
Step 3
Insert Wicking Post through the Pole
Connector.
Step 4
Slide the black retaining washer over
the Wicking Post up to the bottom of the
Pole Connector. Insert hinge pin
through hole in Wicking Post. Note: If
your rope wick becomes unraveled and
frayed at the ends, don’t be concerned,
it will still function as intended.
Step 5
Install Pole Connector into socket where needed. Secure
Pole Connector into socket from top with bolts, washers, and
bushings as shown. Tighten 1000 and 2000 Series Pole
Connectors to 25 lbs/ft (3.46 kg/m) of torque.
3
1
Planter
Wicking
Post
2
Rope
Wick
Self Wicking Planter & Pole Connector