Installation Instructions
31
1-877-742-3071
www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
Pole Pounder & Pole Connector
Instructions for:
Pole Pounder (PP1002)
1000 Pole Connector (PC1010), (PC1010M)
2000 Pole Connector (PC2022),
(PC2022M), (PC2023), (PC2023M)
Pole Cover (PC1002)
Step 1
Determine the length of poles
needed. Start with long poles
and either drive further down
or cut off tops after driving.
Leave extra length above top
of dock at high water elevation.
Step 2
Slip the Pole Connector over
the top of the pole. Attach the
Pole Connector to the dock in
the desired location. Secure Pole
Connectors into sockets with
bolts, washers, and bushings as
shown. Tighten the bolts using
25 lbs/ft
(3.46 kg/m) of torque.
Step 3
Slip the open end of the Pole
Pounder over the top of the pole.
Grab each of the handles and
raise the Pole Pounder up without clearing
the top of the pole. Strike
down on the top of the pole, and continue
striking the pole until the predetermined
depth is reached.
Pound almost to refusal.
Step 4
Note: Check all bolts every three months or as needed to insure all connector
hardware is securely fastened.
Tools Needed
9/16” (16 mm) Socket wrench
3
1
Cover those unsightly 2”
(5.08 cm)
anchor pole tops by
slipping the Pole Cover over
the top of the pole.
2
4