Installation Instructions

29
1-877-742-3071 www.connectadock.com
1501OwnerAvenue,Atlantic,IA50022USA
1000 & 2000 Series Edge Bumper
Instructions for:
Edge Bumper (EB1020)
Tools Needed
Drill - 1/8” (3.5 mm), 3/8” (9.5 mm)
drill bit & 1” (25.5 mm) Wood
bore bit
White or light color marker
9/16” (16 mm) Socket wrench
Saw
Step 1
Determine location of Edge Bumper.
Cut Edge Bumper at the end of Float
Sections if needed. Algin with Dock
edge and mark hole locations up thru
float connector sockets. Straight
Edge Bumper as needed to algin with
dock edge.
Step 2
Drill the holes with 1/8” (3.5 mm) bit
all the way thru the Edge Bumper.
Step 3
(A) Counter shink the holes with 1”
(25.5 mm) Wood bore bit 1” (25.5
mm) deep on opposite side of hole
location marks.
(B) Finish drilling holes with 3/8” (10
mm) bit all the way thru the Edge
Bumper.
Step 4
Place Edge Bumper on dock section
and bolt into place. Tighten all bolts
in the Edge Bumper using 25 lbs/ft
(3.46 kg/m) of torque.
1
2
3
4
Materials Needed
4” x 3/8"-16 (10 cm x 10 mm) bolt,
nut and washer -each hole drilled