User manual

SPEC. NO. L26005 ISSUE DATE 2007-8-2
DESCRIPTION
Rechargeable Lithium Battery (2CR5) &
Worldwide Traveling Charger set
EDITION 0 PAGE
2
/
5
5. Electrical characteristics of Charger
5.1 Output voltage without load : 0-3.6V / 0-7.4V
5.2 Stop for charging : Charging current less than 40mA
5.3 Ripple voltage : 100mV
5.4 Efficiency : 70%
5.5 Power factor : Lager than 0.5
5.6 Maximum temperature of casing after 2 hours of : 40°C
continuous loading of 1A charge
6. Mechanical test of Charger
6.1 Vibration Test
The charger was vibrated in bi-axial direction with 4mm amplitude of 1000 cycles/minute
for 60 minutes in each direction, the charger is observed to be normal.
6.2 Drop Test
The charger was dropped down from the vertical height of 1m onto a flat firm non-
yielding surface by a placing downward three times. The charger is observed to be
normal.
7. Precaution and handling
7.1 The battery to be charged must match charger model.
7.2 If submerged in water. The circuit may be damaged.
7.3 Do not externally short the outline terminal.
7.4 Do not use charger nearby fire, stove or overheat.
7.5 Do not use AC power adaptor other than specified by manufacture.
8. Operation Instructions for Charger Set
7.1 Plug the charger in a wall outlet.
7.2 The LED show flashing Green when the charger is ready.
7.3 Insert battery pack into the charger and LED indicator turns Red when charging.
7.4 When the battery pack is fully charged, the LED indicator flashing Green.
7.5 After fully charged the battery pack, unplug the charger from power outlet and remove
the battery pack from the charger battery compartment.