User manual

Installation of a GALEP-5 driver for USB port
When the GALEP-5 is first connected to a Windows PC, the Windows hardware
assistant activates automatically to install a new hardware driver. Prior to this step,
make sure the required driver files have been pre-loaded on the PC. The drivers should
be available at this step either by having pre-installed the software from the CD –
(typically to the subdirectory: "C:\programs\GALEP5\G5Driver") - or the drivers
should be otherwise available from the G5Driver subdirectory of the Galep5 software
CD, which should have been ready-loaded at this point).
Important! The installation process will vary slightly depending on the Windows
version running on your PC. In all cases, do not
initiate a Windows Assistant
automated search for any driver - you will instead need to enter / select one or the
other, of the 2 directories mentioned above (i.e. either the installed Galep software
driver subdirectory, or the driver subdirectory located on the loaded CD).
After connecting the GALEP-5 to an USB cable and to the PC, initially only the white
LED will blink. After a short pause, the embedded LINUX boot process will
complete. Shortly afterwards, the red LED will light up, and a dialogue box will
display onscreen asking if you wish to open a connection via the automated Windows
updater utility to seek an appropriate driver. Here you will need to select the "No"
option, and then click.
In the next dialogue window, you’ll need to select the option requesting that only
software from a specified source is to be installed. After this option is selected, click
"Continue" again.
In the next step, select "Browse" and open a navigation window – steer the process to
the subdirectory where your "G5Driver" is located (either from CD or C:\programs).
Conclude this step by clicking "OK", and then click.
N
ow the option "Conitec GALEP-5 Programmer" should be selected. Proceed then
click all the following "Continue" buttons (or similar) until all the installation
windows have completed and are closed.
After a successful installation, you should find an entry for the GALEP-5 in the
Windows network environment, this connection is set up and used by the GALEP-5
software. You can also use any web browser with the IP address
192.168.167.12
to get
some device information from the GALEP-5.
GALEP-5D over Ethernet port
Alternately, GALEP-5D can be connected via Ethernet. The default IP address on the
Ethernet
p
ort is
192.168.1.13
. The address can be chan
g
ed via a web browser.
Seite 1 von 1USB driver installation
04.02.2008file://Z:\USBDrvInstall
_
en.html