User`s guide

Copyright © 2012 congatec AG TCEDm10 87/94
9.4.15 Network Stack Submenu
Feature Options Description
Network Stack Disabled
Enabled
Enable/Disable the Network Stack for UEFI.
Ipv4 PXE Support Disabled
Enabled
Enable Ipv4 PXE Boot Support. If disabled Ipv4 PXE Boot option will not be created
Ipv6 PXE Support Disabled
Enabled
Enable Ipv6 PXE Boot Support. If disabled Ipv6 PXE Boot option will not be created
9.5 Boot Setup
Select the Boot tab from the setup menu to enter the Boot setup screen.
9.5.1 Boot Settings Conguration
Feature Options Description
Setup Prompt Timeout 1
0 - 65535
Number of seconds to wait for setup activation key.
0 means no wait for fastest boot, 65535 means innite wait.
Bootup NumLock State On
Off
Select the keyboard numlock state.
System Off Mode G3/Mech Off
S5/Soft Off
Dene system state after shutdown when a battery system is present.
Quiet Boot Disabled
Enabled
Disabled displays normal POST diagnostic messages.
Enabled displays OEM logo instead of POST messages.
NOTE: The default OEM logo is a dark screen.
Power Loss Control Remain Off
Turn On
Last State
Species the mode of operation if an AC power loss occurs.
Remain Off keeps the power off until the power button is pressed.
Turn On restores power to the computer.
Last State restores the previous power state before power loss occurred.
Note: Only works with an ATX type power supply.
AT Shutdown Mode System Reboot
Hot S5
Determines the system’s behavior, when shutting down the system working on AT Mode. The system can reboot or stay on a Hot
S5 power state. When the system is ATX powered, this setup node has no effect.
CPU Reset Mode Warm Reset
Cold Reset
Select the type of reset to be initiated by the Reset Control Register (0xCF9).
Warm reset performs a CPU soft reset.
Cold reset performs a full hard rest (power off/on reset).
Boot Logo Disabled
Enabled
Auto
If Disabled, no congatec OEM boot logo shows during POST. The system shows only POST strings and congatec boot logo.
If Enabled, a congatec OEM logo or a black screen shows during POST. The black screen shows only if the OEM logo is not found.
If Auto, a congatec OEM boot logo loads if present. If no OEM boot logo is found, the system shows POST strings and congatec
boot logo.