User`s guide
Copyright © 2012 congatec AG TCEDm10 66/94
3E8h – 3EFh
3F8h – 3FFh
778h – 77Fh
A00h – BFFh
Parts of these ranges are not available if a Super I/O is used on the carrier board. If a Super I/O is not implemented on the carrier board,
then these ranges are available for customer use. If you require additional LPC Bus resources other than those mentioned above, or more
information about this subject, contact congatec technical support for assistance.
8.3 Interrupt Request (IRQ) Lines
Table 30 IRQ Lines in PIC mode
IRQ# Available Typical Interrupt Source Connected to Pin
0 No Counter 0 Not applicable
1 No Keyboard Not applicable
2 No Cascade Interrupt from Slave PIC Not applicable
3 Yes IRQ3 via SERIRQ or PCI BUS INTx
4 Yes IRQ4 via SERIRQ or PCI BUS INTx
5 Yes IRQ5 via SERIRQ or PCI BUS INTx
6 Yes IRQ6 via SERIRQ or PCI BUS INTx
7 No Reserved for BIOS purposes
8 No Real-time Clock Not applicable
9 No SCI Not applicable
10 Yes IRQ10 via SERIRQ or PCI BUS INTx
11 Yes IRQ11 via SERIRQ or PCI BUS INTx
12 Yes IRQ12 via SERIRQ or PCI BUS INTx
13 No Math processor Not applicable
14 Yes PCI BUS INTx
15 Yes PCI BUS INTx
Note
In PIC mode, the PCI bus interrupt lines can be routed to any free IRQ.