User`s guide

4.1.10 LCD

The Intel

Atom™ D2000/N2000 series processors on the conga-TCA offers a single channel LVDS interface. There is one LVDS transmitter

channel in the LVDS interface and it consists of 4-data pairs and a clock pair each. The LVDS data pair is used to transfer pixel data as well as

the LCD timing control signals.

The N2000 series CPUs found on the conga-TCA support 1x18 bpp only. The D2000 series support both 1x18 bpp and 1x24 bpp.

4.1.11 SPI

A SPI interface that supports booting from an external SPI ash is available on the conga-TCA via the Intel

CG82NM10 (NM10) PCH . The

Intel

CG82NM10 (NM10) PCH implements a SPI interface as an alternative interface for the BIOS ash device. A SPI ash device can be used

as a replacement for the Firmware Hub

4.1.12 General Purpose Serial Interface

Two TTL compatible two wire ports are available on Type 6 COM Express modules. These pins are designated SER0_TX, SER0_RX, SER1_

TX and SER1_RX. Data out of the module is on the _TX pins. Hardware handshaking and hardware ow control are not supported. The module

asynchronous serial ports are intended for general purpose use and for use with debugging software that make use of the “console redirect”

features available in many operating systems.

Note

The General Purpose Serial Interface is not supported on the conga-TCA module.

4.1.13 General Purpose Input/Output

The conga-TCA provides various general purpose inputs and outputs for custom system design. These GPIOs are provided via Intel

CG82NM10

(NM10) and routed to the A,B connector through the congatec Board Controller (STM32F100R8).